olor Yellow
Viscosity at 25°C 25 mPa·s
Density 0.82 g/ml
Drying time 30–90 seconds
Coverage (at 0.05 mm film thickness) 20 m² per liter

Shake well before use!

The surfaces to be bonded must be clean and free of oil and grease. For example, by cleaning with isopropyl alcohol (IPA).

Apply the adhesion promoter using a cloth, roller, felt ball, or similar tool. Clean or replace the tool regularly. Cleaning can be done with acetone-based solvents.

Apply a thin, even layer to the surface to be bonded, using as little product as possible to completely cover the surface. A wet film thickness of 0.05 mm or less is recommended. Although drying times may vary due to temperature and/or humidity, a drying time of 30–90 seconds is typical for this film thickness.

The adhesion promoter must be dry before the adhesive is applied. For best
results, apply the adhesive within one hour of applying the adhesion promoter.

Since the composition of the substrate and the surface energy may vary, each application should be tested for compatibility.